To support the uhaul discount code november 2017 facilitys claim of technical or economic infeasibility, a videotape, a technical report or other documentation shall be submitted to the Department showing either independently or in combination, the following: (i) The production speed is too high or the part shape is too complex.
The solvent used for line cleaning shall be pumped or drained into a normally closed container.(iii) The press is operated with one or a combination of the following inks, coatings or varnishes: (A) Waterborne coatings.(ii) Authorization for open burning under this paragraph does not apply to clearing and grubbing wastes transported from an air basin for disposal outside of an air basin.Code 129.52d (relating to control of VOC emissions from miscellaneous metal parts surface coating processes, miscellaneous plastic parts surface coating processes and pleasure craft surface coatings and.An owner or operator of a facility subject to the work practice standards of 129.103 shall demonstrate continuous compliance by following the work practice implementation plan and submitting a compliance certification which states that the work practice implementation plan is being followed, or should otherwise.(e) Spray booth cleaning.The actual length of the start-up exemption, if any, will be determined by the Department or appropriate approved local air pollution control agency at the time of the issuance of the plan approval or operating permit.A superheated vapor system shall be an acceptable alternate technology.No person may permit the emission into the outdoor atmosphere, at any time, from a nitric acid production plant or facility, of nitrogen oxides, expressed as NO2, in excess of the rate.5 pounds per ton of acid produced, the production being expressed.If the parts or parts basket being cleaned occupy more than 50 of the solvent/air interface area, the speed of the parts or parts basket may not exceed 3 feet per minute.2478; amended May 6, 1988, effective May 7, 1988,.Immediately preceding text appears at serial pages (254494) to (254496).(iii) For a residual oil-fired or other liquid fuel-fired combustion unit or process heater with a rated heat input equal to or greater than 50 million Btu/hour,.20 lb NOx/million Btu heat input.The owner or operator of an offset lithographic printing press or a letterpress printing press subject to this section shall demonstrate compliance with the VOC content limit or VOC composite partial vapor pressure limit for cleaning solutions in subsection (c 1) by one or more.
E-1 Rapid Setting 0 E-2 Rapid Setting (Anionic) 0 E-3 Rapid Setting (Cationic) 3 E-4 Medium Setting 12 E-5 Medium Setting 12 E-6 Slow Setting (Soft Residue) 0 E-8 Slow Setting (Hard Residue) 0 E-10 Medium Setting (High Float) 7 E-11 High Float 7 E-12.
(v) Additional sources approved by the Department.
High bake coating A coating designed to cure only at temperatures of more than 90C (194F). 129.302.Mww Molecular weight of water, 18 grams per g-mole.An owner or operator of a facility subject to the emission standards in 129.102 (relating to emission standards) shall demonstrate compliance with those provisions by using one or more of the following methods: (1) To support that each sealer, topcoat and strippable spray booth coating meets. 4005(a 1) and (8).High Bake CoatingsInterior and Exterior Parts Flexible Primer.54.5 Nonflexible Primer.42.5 Basecoat.52.3 Clear Coat.48.0 Non-basecoat/Clear Coat.52.3. .